Map and Compass for Beginners: The Three Norths and Your First Bearing

A phone with a mapping app is a wonderful tool right up to the moment it gets cold, wet or empty. A paper map and a baseplate compass never run out of battery, and the skills they teach make a young person calm and useful when a group gets turned around. This guide covers the two things every beginner should master before a first overnight trip: understanding the three norths, and taking a bearing from a map and following it on the ground.

Choosing a compass and a map you can actually use

We recommend a simple baseplate compass with a rotating bezel marked in two-degree steps, a clear plastic base with a direction-of-travel arrow, and a magnifier if possible. Mirror and lensatic compasses have their place, but they add steps and cost that beginners do not need. Avoid button compasses and anything built into a whistle; they point roughly north and that is all.

For the map, use a topographic sheet at 1:50,000 or, better for learning, 1:25,000. In Canada the national topographic system covers the whole country at 1:50,000, and many provincial parks publish more detailed trail maps. At 1:50,000, one centimetre on the paper is 500 metres on the ground (roughly 1.25 inches to the mile). Fold the map so the area you are walking in is on the outside, slide it into a zip bag, and keep it in a chest pocket. A map at the bottom of a pack is a map nobody looks at.

The three norths, explained without tears

Every map involves three norths, and confusing them is the number one beginner error.

True north is the direction to the geographic North Pole, the point the Earth spins around. Lines of longitude on a map run to true north.

Grid north is the direction the vertical grid lines on a map point. Because a flat sheet cannot perfectly represent a curved planet, grid lines are very slightly tilted from true north. In southern Ontario the difference is under one degree, and for walking purposes we treat the two as the same.

Magnetic north is where the compass needle actually points: toward the Earth’s magnetic pole, which currently sits in the Arctic Ocean north of Canada and drifts tens of kilometres each year. The angle between grid north and magnetic north is called magnetic declination, and it is printed in the margin of every topographic map along with the year it was measured and the annual change.

Declination varies a great deal across Canada. In much of southern Ontario in the mid-2020s it is roughly 10 degrees west, meaning the needle points about 10 degrees to the left of grid north. On the coast of British Columbia it is around 16 degrees east, and in parts of the Maritimes it exceeds 17 degrees west. Ignoring a 10-degree error over a 2-kilometre leg puts us about 350 metres off our target, which in thick bush is enough to miss a portage landing or a campsite completely.

Setting declination once, then forgetting about it

Many baseplate compasses let us adjust for declination with a tiny screw or a sliding scale on the bezel. If ours does, set it to the local value (check the map margin or a current declination calculator before the trip) and every bearing we read will be a grid bearing with no arithmetic. If ours does not, we add or subtract each time. The rule for converting a grid bearing from the map to a magnetic bearing for the compass is: with west declination, add it; with east declination, subtract it. In Ontario, a map bearing of 60 degrees becomes a compass bearing of about 70. Write the local value on a strip of tape on the compass so nobody has to remember it under stress.

Taking a bearing from the map

This is the core skill. Practise it on a picnic table first.

  • Lay the map flat. Find where you are (point A) and where you want to go (point B).
  • Place the long edge of the compass baseplate along the line from A to B, with the direction-of-travel arrow pointing toward B. Ignore the needle completely at this stage.
  • Hold the baseplate still and rotate the bezel until the orienting lines inside the housing run parallel to the map’s grid lines, with the orienting arrow pointing to the top of the map.
  • Read the number at the index line. That is your grid bearing. Apply declination if your compass is not adjusted.
  • Lift the compass, hold it flat at chest height, and turn your whole body until the red end of the needle sits inside the orienting arrow. The direction-of-travel arrow now points to B.

Following the bearing on the ground

Nobody walks in a straight line through forest. Instead, sight along the direction-of-travel arrow and pick a feature on that line 50 to 100 metres ahead: a distinctive tree, a boulder, a notch in the skyline. Walk to it by whatever route the terrain allows, then repeat. In dense bush we may be sighting only 20 metres at a time, and it helps to send one person ahead as a marker while the navigator lines them up.

Count paces to track distance. Most people between 12 and 17 take about 65 to 75 double paces per 100 metres on flat ground; measure yours on a sports field before the trip. A loaded group on rough trail moves at roughly 3 kilometres per hour (about 2 miles per hour), slower with elevation gain. Knowing how far we have travelled turns a bearing into a position.

Keep the compass away from anything magnetic. A phone in the same pocket, a knife on the belt, the steel frame of a pack or a wire fence can swing the needle by 20 degrees or more. When a reading looks wrong, step away from the group and take it again.

Checking yourself: back bearings and handrails

Before leaving a known point, take a back bearing by adding or subtracting 180 degrees. If we are heading out on 70, the way home is 250. Write it down. If the group has to retreat in fog or fading light, that number is the difference between a long evening and an emergency.

Use handrails whenever the map offers one: a stream, a shoreline, a ridge line or a power-line cut that runs roughly in our direction. Following a handrail is faster and more reliable than holding a pure bearing. A catching feature beyond the target (a road, a lake, a large marsh) tells us when we have gone too far. If we expected the campsite after 1.5 kilometres and we hit the lake at 2, we have overshot and it is time to stop and think rather than push on.

The final habit is the simplest: every time the group stops, the navigator puts a finger on the map and says out loud where we are and what we expect to see next. Do that at every break and no one will ever be more than one leg from a known point.