Six Knots Every Young Camper Should Know, and the Job Each One Does

A knot is a tool. It is chosen for a job, checked before it is trusted, and undone without a fight when the job is over. Young campers often learn twenty knots and forget nineteen, because nobody told them what each one was for. Six knots, each tied to a specific task you will meet on every trip, practised until your hands know them in the dark and with cold fingers. Learn these six properly and you can pitch a tent, hang a tarp, rescue a dropped rope, bundle firewood and tie a boat to a dock. That covers most of a camping weekend.

Before the list, three words matter. The standing part is the long section of rope that goes off to the load. The working end is the short end you tie with. A bight is a U-shaped bend in the rope that does not cross itself. Every knot description below uses those words, so learn them first and the instructions become simple.

The reef knot: joining two ends of the same rope

The reef knot, also called the square knot, is the first knot most of us learn and the most misused. Its proper job is to tie two ends of the same rope around something: a bundle of kindling, a rolled sleeping pad, a bandage, the neckerchief on a first aid sling. Right over left and under, then left over right and under. The finished knot lies flat, with both working ends coming out on the same side as their standing parts.

Here is the safety rule that matters most: a reef knot must never be used to join two ropes that will carry a load. Under strain, especially with ropes of different thickness or slippery material, it can capsize and slip apart. If you need to join two ropes, use the sheet bend below. If you need to hold a person, use neither. The reef knot binds packages; that is all.

The sheet bend: joining two ropes of different sizes

This is the knot for extending a guy line that came up short, or tying a thin cord to a thick rope. Make a bight in the thicker rope. Pass the working end of the thinner rope up through the bight, around behind both parts of the bight, and tuck it under itself. The thin rope should end up trapped against the thick one. Check that both short ends sit on the same side; if they come out on opposite sides you have tied a weaker left-handed version.

For very slippery or very unequal ropes, pass the working end around a second time before the final tuck. That is a double sheet bend and it holds where the single version might creep.

The bowline: a loop that will not tighten

If you learn one knot to a high standard, make it the bowline. It forms a fixed loop at the end of a rope, a loop that neither slips nor jams, so it can be untied easily after taking a heavy pull. Uses include a loop to throw to someone in the water, an anchor point for a tarp ridge line, a way to tie a canoe painter to a tree, and a hauling loop for a pack up a steep bank.

The classic teaching story goes like this: make a small loop in the standing part, with the standing part underneath. The rabbit (working end) comes up out of the hole, goes round the back of the tree (the standing part), and dives back down the hole. Dress the knot by pulling the standing part against the loop. Always leave a tail at least ten times the rope diameter, and in slippery rope, finish with a half hitch around the loop as a backup.

The clove hitch and two half hitches: ties for poles and posts

The clove hitch is the knot that begins most pioneering projects and secures a rope to a post or a tent pole in seconds. Pass the working end around the pole, cross over the standing part, go around again and tuck the end under the last turn. Two half hitches in the same direction, one on top of the other. Pulled from both sides it holds well; pulled from one side only, it can roll and loosen. So we use it as a start or as a temporary tie, and we back it up with a half hitch if the load might shift.

Two half hitches, its close cousin, is the plainest knot of the six and probably the most used. Pass the working end around a post or ring, then tie two identical half hitches around the standing part. Together they form a loop that tightens around whatever it is tied to and holds well under steady pull. It secures a boat to a dock ring, a tarp corner to a tree, a clothesline to a branch. To untie after a load, push the knot back toward the post to loosen the turns.

If the rope will be jerked or shaken, add a round turn first: two full wraps around the post before the hitches. The round turn takes most of the strain so the hitches stay easy to undo.

The taut-line hitch: a guy line you can tighten

This one earns its place at every tent site. Tied around the standing part of a guy line, it forms a loop that slides when pushed but holds under tension. Pass the working end around the peg, then around the standing part twice inside the loop, then once more outside the loop, and tuck it through. Slide it up the line to tighten the tent fabric; the rain arrives, the nylon stretches, and you tighten again in three seconds without untying anything.

How to practise so the knots stay learned

Knots fade when they are only tied in a hall on a warm evening. Tie them where they belong: the taut-line on a real guy line, the bowline around a real waist, the clove hitch on a real pole. Then make it harder in stages.

  • Tie each knot ten times right-handed, then ten times with the rope facing away from you.
  • Tie them behind your back, then with your eyes shut, then wearing gloves.
  • Time a patrol relay: six knots, six members, one length of rope each, fastest correct set wins.
  • Give each camper a short cord to keep in a pocket for a month and tie a knot at every meal.
  • Before trusting any knot, say its name out loud, check it is dressed and tidy, and give it a firm pull.

Six knots, each with a job. Reef for bundles, sheet bend for joins, bowline for a fixed loop, clove hitch for a start on a pole, taut-line for adjustable guy lines, two half hitches for tying off. The rest of the knot book can wait. These six will keep you dry, safe and useful on every camp we run.

Read next: How Can You Make Fire? Homemade Fire Starters Tested, From Wax-Dipped Cotton to Chips